Precor Discovery Converging Shoulder Press
The Advanced Movement Design™ of the Discovery Series Selectorized Line Converging Shoulder Press has an ergonomic converging axis and independent pressing arm movement. The dual position handles add to user comfort and exercise variety, producing superior user feel and benefits.
Weight stack easily accessible from seated position
Pads are engineered to provide comfort and support for proper form
Accessories Tray is easy to keep clean
Upholstery Premium-quality 3D urethane molded-foam padding for maximum comfort. Fabric meets or exceeds California fire regulations (Bulletin 117, section E). Automotive-grade, two-textured fabric features double top stitching on all seams.
Accessory Holder(s) Yes
Adjustable Seat Yes
Integrated Add-on Weight Yes
Adjustments Gas -assist ratcheting seat adjustment requires only a lift to release the lever. Large adjustment handle includes slip-resistant rubber overmold. Adjustment points are highlighted with a contrasting color for easy identification and use.
Weight Stack Units have fully shrouded weight stacks in full compliance with ASTM and EN standards. Each selector plate is entirely precision-machined on all surfaces. Top plate has replaceable precision self-lubricating bushings. The plates feature a black painted protective finish. Guide rods are precision centerless ground, polished, with corrosion-resistant plating for smooth operation and rust retardation. The weight stack is elevated to facilitate user pin selection from seated position.
Bearings and Pivot Points Oversized, linear, re-circulating ball bearings run on case-hardened shafts and are sealed and self aligning. Pivot points and joints feature motor-grade sealed ball bearings, or sleeve bearings, utilizing either oil-impregnated bronze bushings or pre-lubricated nylon bushings. Bolts are grade 5 or above in all applications.
Pulleys and Cables Glass-fiber-reinforced nylon pulleys for durability, with precision motor-grade ball bearing pulleys. Cable consists of 3/16 inch (7"x19") aircraft cable coated with black pressure-extruded nylon to 1/4 inch or 1/8 inch and coated to 3/16 inch. The cables conform to specification MIL-W-83420D-BARE cable only. When used, redirection pulleys route cables close to frame to minimize chance of external interference.
Frame and Finish The frame is 11 gauge (.120 in) 2x4" electroweld steel racetrack tubing. Movement arms are made of electroweld steel round tubing. The abrasive grit pre-finish is followed by an electrostatically applied, heat-cured powder coat.
Instructional placard Easy to understand exercise placards feature large set-up and start and finish position diagrams that are visibly easy to identify
Water Bottle and Accessories Holder The non-slip drink-and-accessory tray is integrated and features large open, even surface area, easily accessible and easy to keep clean.
General Features Natural converging axis allows for more natural motion and greater range of motion. Dual horizontal and neutral handles allow for varying position of the shoulder joint. Arms counterbalance to 10 pound start weight. Weight Stack 200 lb (91 kg).
Incremental Add-on Weight 1x5 lb / 1x2.3 kg
Standard Shroud Color Pacific Blue Black
Weight Stack (kg/lb) 200 lb / 91 kg
Equipment Dimensions & Weight
Length 61 inches / 155 cm
Width 59 inches / 150 cm
Height 61 inches / 155 cm
Equipment Weight 510 lb / 231 kg