Precor Discovery Diverging Lat Pulldown
The Advanced Movement Design™ of the Discovery™ Series Selectorized Line Diverging Lat Pulldown features independent movement arms and ergonomically shaped rotating handles. This allows for natural user defined movement, greater variety, and increased muscular involvement.
Units have fully shrouded weight stacks in full compliance with ASTM and EN standards. Each selector plate is entirely precision-machined on all surfaces. Top plate has replaceable precision self-lubricating bushings. The plates feature a black painted protective finish. Guide rods are precision centerless ground, polished, with corrosion-resistant plating for smooth operation and rust retardation. The weight stack is elevated to facilitate user pin selection from seated position.
Premium-quality 3D urethane molded-foam padding for maximum comfort. Fabric meets or exceeds California fire regulations (Bulletin 117, section E). Automotive-grade, two-textured fabric features double top stitching on all seams.
Adjustable Seat Yes, gas-assisted ratcheting seat adjustment
Gas -assist ratcheting seat adjustment requires only a lift to release the lever. Easy pull-pin allows for adjustment of the large oversized thigh stabilizer pads which are angled for easier entry and exit. Large adjustment handle includes slip-resistant rubber overmold. Adjustment points are highlighted with a contrasting color for easy identification and use.
Instructional Placard Easy to understand exercise placards feature large set-up and start and finish position diagrams that are visibly easy to identify. QR codes provide quick and easy video instruction from your smart phone.
Bearings and Pivot Points
Oversized, linear, re-circulating ball bearings run on case-hardened shafts and are sealed and self aligning. Pivot points and joints feature motor-grade sealed ball bearings, or sleeve bearings, utilizing either oil-impregnated bronze bushings or pre-lubricated nylon bushings. Bolts are grade 5 or above in all applications.
Water Bottle and Accessories Holder
The non-slip drink-and-accessory tray is integrated and features large open, even surface area, easily accessible and easy to keep clean.
Pulleys and Cables
Glass-fiber-reinforced nylon pulleys for durability, with precision motor-grade ball bearing pulleys. Cable consists of 3/16 inch (7"x19") aircraft cable coated with black pressure-extruded nylon to 1/4 inch or 1/8 inch and coated to 3/16 inch. The cables conform to specification MIL-W-83420D-BARE cable only. When used, redirection pulleys route cables close to frame to minimize chance of external interference.
Frame and Finish
The frame is 11 gauge (.120 in) 2x4" electroweld steel racetrack tubing. Movement arms are made of electroweld steel round tubing. The five-stage material prep/wash process if followed by an electrostatically applied, heat-cured powder coat.
Bolt Down Capability Yes
Diverging axis allows for more natural motion and greater range of motion.
Independent, user defined proprietary handles allow for user’s natural movement , supination and pronation through the pulling range of motion.
Ergonomically fit handles are slip resistant over molded handles.
Incremental Add-on Weight 5 lbs (2.3 kg)
Standard Shroud Color
Weight Stack 240 lbs / 109 kg
Standard Upholstery Color - Black
Workout Area (L x W) 56 L x 50 W / 140 L x 127 W
Equipment Dimensions and Weight
Length 47 inches / 119 cm
Width 50 inches / 127 cm
Equipment Weight 565 lbs / 256 kg
Height 84 inches / 213 cm