Cart 0
Precor Experience Strength™ C-Line Chest Press C404EC

Precor Experience Strength™ C-Line Chest Press C404EC

$ 2,299.00

A foot assist bar on the C-Line Chest Press allows the user to begin exercise in an advantageous pre-stretch start position. The movement arm features forward-set, low pivot for proper motion path. The ratcheting, gas-assisted seat adjusts easily and fits a wide range of users.

General Features
Movement arm features forward-set, low pivot for proper motion path. Ratcheting, gas-assisted seat adjusts to fit wide range of users.

Weight Stack 260 kg (119 lbs).

Instructional placard
Step-by-step machine identifier and instructional placards are positioned on the inside of the weight stack for easy reading by user.

Adjustments Ratcheting seat adjustments require only a lift to release the lever.

Handles include slip-resistant rubber sleeves with machined alloy end-caps.

Adjustment points are highlighted with a contrasting color for ease of use.

Weight Stack Units have fully shrouded weight stacks in full compliance with ASTM and EN standards. Each selector plate is entirely precision-machined on all surfaces. Top plate has replaceable, precision self-lubricating bushings. The plates feature a black-painted protective finish.
Guide rods are precision center-less ground, polished, with corrosion-resistant plating for smooth operation and rust retardation. The weight stack is elevated to facilitate user pin selection from seated position.

Integrated Add-on Weight Yes

Frame and Finish
The frame is 11 gauge (.120 in) 2x4"" electroweld steel racetrack tubing. Movement arms are made of electroweld steel round tubing. The abrasive grit pre-finish is followed by an electrostatically applied, heat-cured powder coat.

Upholstery
Premium-quality, 3D urethane, molded-foam padding for maximum comfort. Fabric meets or exceeds Californian fire regulations (Bulletin 117, section E). Automotive-grade, two-textured fabric features double top stitching on all seams.

Pulleys and Cables
Glass fiber-reinforced nylon pulleys for durability, with precision, motor-grade ball-bearing pulleys. Cable consists of 3/16 inch (7""x19"") aircraft cable coated with black pressure-extruded nylon to 1/4 inch or 1/8 inch and coated to 3/16 inch. The cables conform to specification MIL-W-83420D-BARE cable only. When used, redirection pulleys route cables close to frame to minimize chance of external interference.

Bearings and Pivot Points Over sized, linear, recirculating ball bearings run on case-hardened shafts and are sealed and self-aligning. Pivot points and joints feature motor-grade, sealed ball bearings or sleeve bearings, utilizing either oil-impregnated bronze bushings or pre-lubricated nylon bushings. Bolts are grade 5 or above in all applications.

Water Bottle and Accessories Holder The drink-and-accessory holder features machine-identifier graphics on both sides for easy identification and optional circuit numbering.

Rubber Feet Yes

Weight Stack (kg/lbs) 119 kg/260 lbs
Workout Area (L x W) (cm/inches) 163 x 150 cm/64 x 59 inches
Length (cm/inches) 147 cm/58 inches
Width (cm/inches) 150 cm/59 inches
Height (cm/inches) 170 cm/67 inches
Equipment Weight (kg/lbs) 262 kg/575 lbs

 


Share this Product