Cart 0
Precor Experience Strength™ C-Line Rear Delt / Pec Fly C505EC  - Fitness Trendz USA

Precor Experience Strength™ C-Line Rear Delt / Pec Fly C505EC

$ 2,399.00

The C-Line Rear Delt / Pec Fly features dual independent-movement arms with upper pivots to accommodate varying arm lengths. Each can be set to 13 starting positions over a 120-degree range. The weight is offset to the right for most convenient access.

General Features
Dual independent-movement arms feature upper pivots to accommodate arm lengths and can be set to 13 starting positions over a 120-degree range. Weight stack offset to user's right for the most convenient access.

Weight Stack 260 lbs (119 kg).

Instructional Placard
Step-by-step machine identifier and instructional placards are positioned on the inside of the weight stack for easy reading by user.

Adjustments Ratcheting seat adjustments require only a lift to release the lever.

Handles include slip-resistant rubber sleeves with machined alloy end-caps.

Adjustment points are highlighted with a contrasting color for ease-of-use.

Weight Stack Units have fully shrouded weight stacks in full compliance with ASTM and EN standards. Each selector plate is entirely precision-machined on all surfaces. Top plate has replaceable precision self-lubricating bushings. The plates feature a black painted protective finish.

Guide rods are precision center-less ground, polished, with corrosion-resistant plating for smooth operation and rust retardation. The weight stack is elevated to facilitate user pin selection from seated position.

Integrated Add-on Weight Yes

Frame and Finish
The frame is 11 gauge (.120 in) 2x4"" electroweld steel racetrack tubing. Movement arms are made of electroweld steel round tubing. The abrasive grit pre-finish is followed by an electrostatically applied, heat-cured powder coat.

Upholstery
Premium-quality 3D urethane molded-foam padding for maximum comfort. Fabric meets or exceeds California fire regulations (Bulletin 117, section E). Automotive-grade, two-textured fabric features double top stitching on all seams.

Pulleys and Cables Glass-fiber-reinforced nylon pulleys for durability, with precision motor-grade ball bearing pulleys. Cable consists of 3/16 inch (7""x19"") aircraft cable coated with black pressure-extruded nylon to 1/4 inch or 1/8 inch and coated to 3/16 inch. The cables conform to specification MIL-W-83420D-BARE cable only. When used, redirection pulleys route cables close to frame to minimize chance of external interference.

Bearings and Pivot Points Oversized, linear, re-circulating ball bearings run on case-hardened shafts and are sealed and self aligning. Pivot points and joints feature motor-grade sealed ball bearings, or sleeve bearings, utilizing either oil-impregnated bronze bushings or pre-lubricated nylon bushings. Bolts are grade 5 or above in all applications.

Water Bottle and Accessories Holder The drink-and-accessory holder features machine-identifier graphics on both sides for easy identification and optional circuit numbering.

Rubber Feet Yes

Weight Stack 260 lbs / 119 kg
Workout Area (L x W) 82 x 82 inches / 208 x 208 cm
Length 54 inches / 137 cm
Width 41 inches / 104 cm
Height 84 inches / 231 cm
Equipment Weight 635 lbs / 290 kg

 


Share this Product