Precor Experience Strength™ C-Line Seated Leg Curl C619EC
Ensuring optimal interaction between user and equipment, the knee pad of the C-Line Seated Leg Curl moves with the lower legs – no thigh hold-down panel is required. Start position and roller pads adjust for sound bio-mechanics.
Premium-quality 3D urethane molded-foam padding for maximum comfort. Fabric meets or exceeds California fire regulations (Bulletin 117, section E). Automotive-grade, two-textured fabric features double top stitching on all seams.
Weight Stack Units have fully shrouded weight stacks in full compliance with ASTM and EN standards. Each selector plate is entirely precision-machined on all surfaces. Top plate has replaceable precision self-lubricating bushings. The plates feature a black painted protective finish.
Guide rods are precision center-less ground, polished, with corrosion-resistant plating for smooth operation and rust retardation. The weight stack is elevated to facilitate user pin selection from seated position.
Rubber Feet Yes
Accessory Holder(s) Yes
Integrated Add-on Weight Yes
Step-by-step machine identifier and instructional placards are positioned on the inside of the weight stack for easy reading by user.
Water Bottle and Accessories Holder The drink-and-accessory holder features machine-identifier graphics on both sides for easy identification and optional circuit numbering.
Adjustments Ratcheting seat adjustments require only a lift to release the lever.
Handles include slip-resistant rubber sleeves with machined alloy end-caps.
Adjustment points are highlighted with a contrasting color for ease-of-use.
Bearings and Pivot Points
Over-sized, linear, re-circulating ball bearings run on case-hardened shafts and are sealed and self aligning. Pivot points and joints feature motor-grade sealed ball bearings, or sleeve bearings, utilizing either oil-impregnated bronze bushings or pre-lubricated nylon bushings. Bolts are grade 5 or above in all applications.
Pulleys and Cables
Glass-fiber-reinforced nylon pulleys for durability, with precision motor-grade ball bearing pulleys. Cable consists of 3/16 inch (7""x19"") aircraft cable coated with black pressure-extruded nylon to 1/4 inch or 1/8 inch and coated to 3/16 inch. The cables conform to specification MIL-W-83420D-BARE cable only. When used, redirection pulleys route cables close to frame to minimize chance of external interference.
Frame and Finish
The frame is 11 gauge (.120 in) 2x4"" electroweld steel racetrack tubing. Movement arms are made of electroweld steel round tubing. The abrasive grit pre-finish is followed by an electrostatically applied, heat-cured powder coat.
General Features Knee pad moves with user's lower legs; no thigh hold-down pad required. Start position and roller pads adjust for optimal exercise mechanics.
Weight Stack 260 lbs (119 kg).
Workout Area (L x W) 66 x 50 inches / 168 x 127 cm
Length 64 inches / 163 cm
Width 49 inches / 124 cm
Equipment Weight 640 lbs / 292 kg
Height 67 inches / 170 cm
Listed “As is” $1499
If Cleaned and Serviced $1799
If Certified Pre Owned $2299