Cart 0
Precor Experience Strength™ C-Line Shoulder Press C500EC

Precor

Precor Experience Strength™ C-Line Shoulder Press C500EC

$ 1,499.00

The C-Line Shoulder Press delivers targeted movement, with a movement arm that is counter-balanced with a rear-set pivot designed to create a proper motion path and low starting lift weight. The ratcheting, gas-assisted seat adjusts to fit a wide range of users.

General Features
Movement designed to create optimal motion path. Ratcheting, gas-assisted seat adjusts to fit wide range of users.

Weight Stack 215 kg (98 lbs).

Instructional placard
Step-by-step machine identifier and instructional placards are positioned on the inside of the weight stack for easy reading by user.

Adjustments Ratcheting seat adjustments require only a lift to release the lever.

Handles include slip-resistant rubber sleeves with machined alloy end-caps. Adjustment points are highlighted with a contrasting colour for ease of use.

Weight Stack Units have fully shrouded weight stacks in full compliance with ASTM and EN standards. Each selector plate is entirely precision-machined on all surfaces. Top plate has replaceable, precision self-lubricating bushings. The plates feature a black-painted protective finish.

Guide rods are precision center-less ground, polished, with corrosion-resistant plating for smooth operation and rust retardation. The weight stack is elevated to facilitate user pin selection from seated position.

Integrated Add-on Weight Yes

Frame and Finish
The frame is 11 gauge (.120 in) 2x4"" electroweld steel racetrack tubing. Movement arms are made of electroweld steel round tubing. The abrasive grit pre-finish is followed by an electrostatically applied, heat-cured powder coat.

Upholstery
Premium-quality, 3D urethane, moulded-foam padding for maximum comfort. Fabric meets or exceeds Californian fire regulations (Bulletin 117, section E). Automotive-grade, two-textured fabric features double top stitching on all seams.

Pulleys and Cables
Glass fiber-reinforced nylon pulleys for durability, with precision, motor-grade ball-bearing pulleys. Cable consists of 3/16 inch (7""x19"") aircraft cable coated with black pressure-extruded nylon to 1/4 inch or 1/8 inch and coated to 3/16 inch. The cables conform to specification MIL-W-83420D-BARE cable only. When used, redirection pulleys route cables close to frame to minimize chance of external interference.

Bearings and Pivot
Points Over-sized, linear, recirculating ball bearings run on case-hardened shafts and are sealed and self-aligning. Pivot points and joints feature motor-grade, sealed ball bearings or sleeve bearings, utilizing either oil-impregnated bronze bushings or pre-lubricated nylon bushings. Bolts are grade 5 or above in all applications.

Water Bottle and Accessories Holder The drink-and-accessory holder features machine-identifier graphics on both sides for easy identification and optional circuit numbering.

Rubber Feet Yes

Weight Stack (kg/lbs) 98 kg/215 lbs
Workout Area (L x W) (cm/inches) 165 x 132 cm/65 x 52 inches
Length (cm/inches) 165 cm/65 inches
Width (cm/inches) 132 cm/52 inches
Height (cm/inches) 170 cm/67 inches
Equipment Weight (kg/lbs) 258 kg/565 lbs

Unit Options

Listed “As is” $1499

If Cleaned and Serviced $1799

If Certified Pre Owned $2299

 

 


Share this Product